Filter
Top Products
Normal Removal &
Installation
12
Normal Removal & Installation
Collector Installation
Note: See previous pages for more detailed installation
and operation instructions if necessary.
38” Free Floating Mowers
1. Lift discharge deflector up (E, Figure 21).
2. Slide the notch of bracket (G) on to deflector hinge
rod (F).
3. Secure the front of lower chute (A) to carriage bolt
(D) using wing nut (B).
42” and 38” Frame Hung Mowers
1. Lift discharge deflector up (E, Figure 22).
2. Place the front hole of the lower chute (A) onto
carriage bolt (C) as shown. Slide front edge of lower
chute (A) under hinge bracket (G).
3. Place the rear hole of the lower chute (A) onto
carriage bolt (F) as shown.
4. Secure knob (B) onto carriage bolt (C) as shown.
5. Secure wing nut (D) onto carriage bolt (F) as shown.
All Mowers
4. Mount the the channel assembly (A, Figure 23) into
hitch (D). Secure by inserting pin (C) into the right
side of hitch (D) and turning pin (C) counterclockwise
to lock in place.
5. Pivot cover (B) up. Install bags (E) with white bar (F)
towards the rear.
6. Slide the upper and middle tube (J) aligning ridge (L)
with cutout (M) as shown.
7. Slide middle and upper tube (J) over lower chute (H).
Pull strap (K) and place hole completely over pin (I).
A
F
B
Figure 21. Install Lower Discharge Chute 38” Free
Floating Mowers
A. Lower Chute
B. Wing Nut
C. Rubber Strap
D. Carriage Bolt
E. Discharge Deflector
F. Deflector Hinge Rod
G. Bracket
D
C
E
G
C
E
D
A
B
Figure 22. Install Lower Discharge Chute 38” Free
Floating Mowers
A. Lower Chute
B. Knob, 5/16-18
C. Front Carriage Bolt, 5/16-18 x 3/4
D. Wing Nut, 5/16
E. Discharge Deflector
F. Rear Carriage Bolt, 5/16-18 x 3/4
G. Hinge Bracket
F
G