6
Installation Instructions Lift Lever Kit
Install Tunnel
1. Set the tunnel on the tractor frame and slide it for-
ward under the dashboard.
2. Secure the tunnel to the frame using the original
hardware.
3. Reinstall the foot pedals (A, Figure 12).
4. Reinstall the cruise control knob.
Modify Mower Deck
ALL MODELS
1. Remove and discard the washer and cotter pin (A,
Figure 14) securing the lift link (B). Retain the lift link
(B). for 38”, 40” and 44” mowers. Discard the lift link
(B) for 50” mowers.
Figure 13. Seat Deck Removal
A. Foot Rest Screws (Two per Side)
B. Top Seat Deck Screws
B
A
Seat Removed
for Clarity
A
A
Figure 12. Pedals
A. Foot Pedals
Install Seat Deck
1. Reinstall the gas tank, if removed. Remove the gas
cap.
2. Set the seat deck down on the seat deck support.
Route the seat switch wire harness though the hole in
the center of the seat deck.
3. Reinstall the gas cap.
4. Secure the seat deck with the original taptite screws
(B, Figure 13), foot rest screws, & nuts.
5. Reconnect the seat switch wire harness.
6. If equipped, install the cruise control knob.
9. Reinstall the right rear wheel.
B
A
Figure 14. Remove Mower Lift Link
A. Washer & Cotter Pin
B. Lift Link