Filter
Top Products
4
Installation Instructions Lift Lever Kit
A
Figure 8. Install Return Spring
A. Return Spring
Install Return Spring
1. Insert the return spring (A, Figure 8) through the lift
shaft assembly from the bottom and hook the front
leg of the spring on the top edge of the lift arm.
2. Route the spring around the bottom of the shaft and
hook the back leg on the notch in the plate.
A
B
C
D
E
A
F
C
D
G
Figure 9. Connect Lift Link
A. Pin
B. Rear Hole of Lift Bar (Snowthrower Applications)
C. Spacer
D. Hair Pin Clip
E. Upper Hole (Snowthrower Applications)
F. Slot of Lift Bar (Mower Applications)
G. Lower Hole (Mower Applications)
Snowthrower
Applications
Mower
Applications
Install Lift Link
1. Connect the lift bar to the lift shaft assembly. Note
that the pin (A, Figure 9), spacer (C), and hair pin clip
(E) are installed in different positions depending on
what attachment is to be used.