Filter
Top Products
10. The baffle (A, figure 7) is installed in the blower
housing for use with 42” mower. For use with
48” mower, remove the baffleand install in holes
marked 48”.
I
Figure 7.
A Battle
NOTE
On42”and 48” mowersthecapscrewinstalled
in next step is used in the hole occupied by a
screw held in place by a retaining nut. (This
screw secured the right-front corner of the
arbor cover.) Remove this screw(s) from
mower deck by tapping out with a hammer or
prying off the retaining nut.
11. Install the pulley cover (B, figure 8) with
hardware shown, items E through M. (Figure 8
shows blower housing but it is not installed at
this point of the procedure.)
In
:
. .
.
.
-..._
A. Blower Housing
q
. Pulley Cover
C. Hook
D. Clip
E.
Capscrew
F. Washer,
5116
G. Large Washer, 5/16
H. Spacer
I.
Lockwasher, S/16
J. Nut. 506
K.
La&
Washer, S/16
L. Large Washer, 5/16
I
M. Locknut, S/16
N. Wing Nut
5