Filter
Top Products
16. Make sure that flat washer (F, figure
9)
is on top of
spacer assembly and install new arbor belt cover (A,
figure 10) as shown in figure 10. Secure with flat
washer (l-1/4” O.D.) and locknut
(8).
Belt cover
should be free to pivot.
17. Install the blower assembly as follows:
a. Align th& notch on blower assembly with
spacer on arbor bracket. Align spacer on
blower assembly with notch on arbor bracket.
Slide the assembly into place as shown in
figure 10 while aligning front notch between
cup and wing nut. Tighten wing nut (C, figure
10).
b. Raise the flap (D, figure 10) and install the
blower drive belt (E) in the top groove of the
pulley. Push on lever (F) to provide slack to
install belt.
NOTE
On later models with single (front) belt stop,
belt stop must be on outside of both mower
belt and turbo belt.
Figure
10.
A. Arbor Cover
’
B. Locknut
C.
Wing
Nut
D. Flap
E. Blower Belt
F.
Lever
G. Rat Washer
(l-1/4’
O.D.)
18. With belt installed, pivot arbor cover (A, figure
11) into position as shown in figure 11. Secure
with rubber strap (B) to blower housing.
12
:igure
11.
A
Arbor Cover
8.
Rubber Strap