Filter
Top Products
Attaching the Hopper
1. See Figure 4. Attach the hopper to the rotor hous-
ing, using care to engage the metal lip of the hopper
liner to the inside of the housing.
2. Secure the hopper to the rotor housing using (2)
5/16 x 1/2 hex head bolts and (2) 5/16 flat washers.
Do not tighten hardware at this time.
9
Assembling the Chipper/Shredder
Figure 4. Attaching Hopper to the Rotor
Figure 5. Installing Hardware Inside Hopper
3. See Figure 5. From the inside of the hopper, install
(1) 5/16-18 x 3/4 hex head bolt, 5/16 lockwasher,
and 5/16 flat washer into each of the upper and
lower holes of the metal hopper liner. Do not tighten
at this time.
4. Make sure the hopper is properly seated on the rotor
housing, and then tighten all hardware securely.