Filter
Top Products
15
English
aIr fIlter
Level 1.
Tools required: 25-50 mm (1-2 in.) Cleaning brush.
NOTE
Clean daily.
Close choke (Cold Start Position [ ]). This prevents dirt from enter-
ing the carburetor throat when the air lter is removed. Brush accumu-
lated dirt from air cleaner area.
Remove air lter cover. Brush dirt from inside cover.
Remove air lter and lightly brush debris from lter. Replace lter if
it is damaged, fuel soaked, very dirty, or the rubber sealing edges are
deformed.
If lter can be reused, be certain it:
• Fits tightly in the air lter cavity.
• Is installed with the original side out.
Install air lter cover.
fuel fIlter
Level 1.
Tools required: 200-250 mm (8-10 in.) length of wire with one end
bent into a hook, Clean rag, funnel, and an approved fuel container.
WARNING
Fuel is VERY ammable. Use extreme care when mixing, storing
or handling.
Use a clean rag to remove loose dirt from around fuel cap and empty
fuel tank.
Use the “fuel line hook” to pull the fuel line and lter from the tank.
Remove the lter from the line and install the new lter.
1.
2.
3.
4.
5.
1.
2.
3.