Shindaiwa DG150MI Portable Generator User Manual


 
- 9 -
5 Equipment
5.1 Monitor Display
[DG250MI] [DG150MI]
WATER TEMP OIL PRESS CHARGE AIR FILTER
FUEL LEVELBATTERY LOW LEVEL
DG250MI is equipped with monitoring function for water/coolant temperature, oil pressure, battery charge, air
filter flow, battery fluid level, and fuel level. DG150MI is equipped with monitoring function for water/coolant
temperature, oil pressure and battery charge.
When the equipment is started under normal condition, Oil Pressure and Battery Charge lamps will flash when
the Starter Switch is turned from STOP to OPERATING, and all lamps will go off, immediately after the engine
is started.
When the abnormality is detected either in water temperature or in oil pressure, the corresponding monitor
lamp will flash, and the automatic shutoff shall be engaged.
When the automatic shutoff is engaged, turn the starter switch to STOP position, then restart the engine.
When the automatic shutoff is engaged next time, check all parts of the corresponding alarm.
5.1.1 Water Temperature Monitoring Lamp (for temperature High)
!
Danger
: Injuries
Close all doors and place locks during operating this equipment, to avoid injuries by
unintentionally touching cooling fan and fan belt.
!
Caution
: Burns
Do not open the radiator cap while operating this equipment or immediately after
stopping the equipment, to avoid sustaining burns from hot vapor.
Do not touch the engine and muffler during operation and immediately after stopping
the equipment, for the temperature can reach extremely high.