Filter
Top Products
- 14 -
2.2.6.2 Pilot Lamp [DG250MI only]
Pilot Lamp indicates whether or not the generator is generating electricity,
when the engine is driving.
5.2.7 Switch
5.2.7.1 Starter Switch
STOP
When the switch is set to this position, all power will be off. The switch must be
set to this position to remove the key.
RUN / PREHEAT
The switch must be set to this position during operation. This position is also
used during cold season, to preheat Glow Plug.
<Caution>
Do not leave the switch to this position, while the engine is stopped.
A battery discharges.
START
This position will allow user to start the engine. When a user release the key,
the setting will automatically return to <Operating / Preheating> position.
5.2.7.2 Panel Light Switch
This switch turns Panel Light to ON and OFF. The switch can only be used when the
Start switch is in OPERATING position.
5.2.7.3 Emergency Stop button [DG250MI only]
This button is used to stop the engine in emergency. Keep pressing the button until the
engine comes to complete halt.
<Caution>
Keep pressing the button until the engine stops in several seconds.
After the engine stops, be sure to return the starter switch to the STOP Position.
5.2.7.4 Circuit Breaker
By turning this circuit breaker switch to ON position, power will be transferred to the
output terminal and to the load side. By turning to OFF position, it will shut down all power
to the load side, preventing overload and short-circuit, and also breaking the earth
leakage.
<Caution>
Do not use this breaker as the ON/OFF switch to the load.
The earth leakage breaking function is for 3-Phase circuit only, not 1-Phase Circuit.