Filter
Top Products
13
OPERATION
If the starter does not turn the engine over, shut off
starter immediately. Do not make further attempts to
start the engine until the condition is corrected.
SAFETY INTERLOCK SWITCHES
Your RANSOMES tractor is equipped with three
interlock switches, P T 0 clutch lever, brake and
seat. The engine can be started only when the
P.T.O. clutch lever is in the “OFF” position and when
the brake pedal is depressed. If even one of them is
not applied the engine cannot be started. The
engine will continue to run without an operator in the
seat only if the brake pedal is locked down and
P.T.O. clutch is disengaged.
STARTING THE TRACTOR WITH JUMPER
CABLES
WARNING: To avoid injury always start
engine from the operator’s seat. If
safety start switch is bypassed, engine
can start with transmission in gear.
If it is necessary to use jumper cables to start the
tractor, follow the instructions below;
1 Shield eyes.
2. Connect one end of the jumper cable to the
tractor battery positive (+) terminal and the
other to the auxiliary battery positive (+)
terminal. Connect one end of the other cable
first to the auxiliary battery negative (-)
terminal, and the other end to the tractor
starter ground terminal. Follow the starting
procedures above after the jumper cables are
connected as instructed.
Idle the engine and turn on electrical equipment
(lights, etc.) , then disconnect the cables in reverse
order of the connecting procedure above. This will
help protect the alternator from damage due to
extreme load changes.
WARNING: Batteries contain sulphuric
acid and produce explosive gases.
Follow the instructions below to prevent
personal injury.
l Wear eye and skin protection.
l Keep sparks and flame away.
l Always have adequate ventilation while
charging or using the battery.
l Follow the battery manufacturer’s instructions
which are shown on the battery.
l If ice is present or the battery is cracked, DO
NOT ATTEMPT TO “JUMP START” vehicle.
l Bring helper vehicle with a battery of the
same voltage as disabled machine within
easy cable reach “THE VEHICLES MUST
NOT TOUCH”.
STOPPING THE ENGINE
Stopping the engine should be done according to
the following procedures,
Pull the throttle lever fully rearward.
2. Place the speed control lever in the
“RELEASE” position, and release the H.S.T.
foot pedal.
3. Set and lock the brake pedal.
4. Place the range shift and lift control levers in
the “LOCK” position.
5. Turn the key start switch to the “OFF”
position.
6. Remove the key
IMPORTANT: Failure to turn the key start switch to
the “OFF” position after the engine stops will allow
the warning lights to remain on, causing the battery
to discharge.