Filter
Top Products
37
XL-UH2080H
References
Care of compact discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
z Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
z Keep your discs away from direct sunlight, heat, and excessive
moisture.
z Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
Maintenance
Cleaning the CD pickup lens
In order to ensure proper operation of the CD player, preventative
maintenance (cleaning of the laser pickup lens) should be
performed periodically. Lens cleaners are commercially available.
Contact your local CD software dealer for options.
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
z Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
z Do not apply oil to the inside of the unit. It may cause
malfunctions.
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product im-
provement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
General
Amplifier
YES
Correct
NO
Power source AC 220 - 240V ~ 50Hz
Power consumption Power on: 40 W
Power stand-by: 0.6 W (*)
Dimensions Width: 180 mm (7 - 1/16")
Height: 260 mm (10 - 2/8")
Depth: 273 mm (10 - 6/8")
Weight 4.0 kg (8.8 lbs.)
( * )This power consumption value is obtained when the
demonstration mode is cancelled in the power stand-by mode.
Refer to page 10 to cancel the demonstration mode.
Output power PMPO : 128 W
MPO : 64 W (32 W + 32 W) (10% T.H.D.)
RMS: 64 W (32 W + 32 W) (10% T.H.D.)
RMS: 40 W (20 W + 20 W) (1% T.H.D.)
Output terminals Speakers: 4 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Subwoofer pre-out (audio signal):
150 mV/10 k ohms at 70 Hz
Input terminals Audio In (Audio signal):
250 mV/47 k ohms