Filter
Top Products
24
XL-UH2080H
Radio
Listening to radio (continued)
Tuning
Notes:
z When radio interference occurs, auto scan tuning may stop
automatically at that point.
z Auto scan tuning will skip weak signal stations.
z
To stop the auto tuning, press the TUNING ( or ) button again.
z When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator will
light up. Finally, the station name will appear.
z Full auto tuning can be achieved for RDS stations “ASPM”, see
page 26.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to select stereo mode and “ST”
indicator will be displayed.
z “ ” will appear when an FM broadcast is in stereo.
z If the FM reception is weak, press the TUNER (BAND) button to
extinguish the “ST” indicator. The reception changes to
monaural, and the sound becomes clearer.
Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead become
disconnected.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM or AM).
3 Press the TUNING ( or ) button on the remote control
to tune in to the desired station.
Manual tuning:
Press the TUNING ( or ) button as many times as required
to tune in to the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
FM stereo mode indicator
FM stereo receiving indicator
1 Perform steps 1 - 3 in “Tuning” on page 24.
2 Press the MEMORY button to enter the preset tuning
saving mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY button to store that
station in memory.
If the “MEMORY” and preset number indicators disappear
before the station is memorised, repeat the operation from step
2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.