Filter
Top Products
35
XL-UH2080H
References
Subwoofer connection
When a commercially available subwoofer with a built-in amplifier is
connected to this unit, you can enjoy sound with emphasised bass.
Connect an RCA lead from a commercially available speaker with a
built-in amplifier to the SUBWOOFER PRE-OUT socket.
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
CD player
Subwoofer with a
built-in amplifier
Symptom Possible cause
z The clock is not set to the
correct time.
z Did a power failure occur? Reset
the clock. (Refer page 13)
z When a button is pressed,
the unit does not respond.
z Set the unit to the power stand-
by mode and then turn it back on.
z If the unit still malfunctions, reset
it. (Refer page 36)
z No sound is heard. z Is the volume level set to “0”?
z Are the headphones connected?
z Are the speaker wires
disconnected?
Symptom Possible cause
z Playback does not start. z Is the disc loaded upside down?
z Playback stops in the
middle or is not performed
properly.
z Does the disc satisfy the
standards?
z Is the disc distorted or
scratched?
z Playback sounds are
skipped, or stopped in the
middle of a track.
z Is the unit located near excessive
vibrations?
z Is the disc very dirty?
z Has condensation formed inside
the unit?