Filter
Top Products
ASSEMBLY
Turbo120 01/11 Assembly Section 3-11
© 2011 Alamo Group Inc.
ASSEMBLY
CHECK CHAINS (Extra Equipment) LIFT MODELS
Check Chains are available for attachment to the front of the cutter as an accessory. Check Chains are used to
control the cutting height and especially to allow the cutter to be lowered to the same preset cutting height
effortlessly.
Install lower end of Check Chain (4) to Hitch Ears (6) through hole (7) [See Hole Note and Figure Asm-R-]
using Bolt (8), Lockwasher (9) and Nut (10). Tighten securely.
Install Chain Lugs (3) on either side of tractor Top Link Mounting (5) using Bolt or pin (2) of required diameter
and length. Cat I kit requires a 3/4” diameter Bolt. Cat II kit requires a 1” diameter Bolt. Install top end of Check
Chains in brackets (3).
Cutting height is then set by placing proper chain link in keyhole slot. Cutting height is easily adjustable by
hooking chain higher or lower in the keyholes in chain lug (3). Figure Asm-R-0300
For additional safety in transport, raise mower as high as possible without having driveline
hit deck and shorten check chain as much as possible to prevent inadvertent falling in
transport.
HOLE NOTE:
A 11/16” diameter hole must be
drilled through the inside hitch lug
according to the dimensions shown.
Figure Asm-R-0299