Filter
Top Products
ASSEMBLY
Turbo120 01/11 Assembly Section 3-2
© 2011 Alamo Group Inc.
ASSEMBLY
DEALER SETUP INSTRUCTIONS
The mower as recieved from the factory is partially assembled and requires minimum time to complete
assembly and is ready for sale.
This mower is shipped vertically with shipping brackets. These shipping brackets are intended for use in
transporting the mower from the factory to dealer.
DO NOT use these brackets to
store the unit. DO NOT store
mower vertically, the mower can
fall over resulting in serious injury or death. To
avoid injury always store mower lying down on flat
ground.
Assembly will be easier if comonents are aligned
and loosely assembled before tightening hardware.
Refer to bolt torque chart in Maintenance Section.
All bolts are grade 5 unless otherwise specified.
A-FRAME ASSEMBLY-LIFT TYPE
1. Insert bushing (8) into lower end of each A-Frame half (1 & 2). Position each A-Frame half inside Main
Frame Lug. Install bolt (17) with Flatwasher (14) through bushing (8) in A-Frame half (1 & 2) and hole in
inside Main Frame lug. Install locknut(6).
2. Install bushing (15) between braces (3) through top rear hole of A-frame and insert bolt (16), flatwasher
(14) and locknut (6). Install Driveline Holder Bracket (21) to left A-Frame (2) with bolt (10) and locknut (9).
3. Install bushing (11) between A-Frame halves (1 & 2) and insert bolt (13) and locknut (12). Then attach
braces (3) and brace (4) by installing bushings (8) through brace (4) and install bolt (7), and locknut (6)
through braces (3) and brace (4). Then attach another bushing (20) in between braces (3) with bolt (7), and
locknut (6).
4. Install Brace supports (4) to the rear lugs on the Main Frame with pivot pin(22) and retain with bolt (10) and
locknut (6). Figure Asm-R-0305