Filter
Top Products
ASSEMBLY
CY72 01/08 Assembly Section 3-8
© 2008 Alamo Group Inc.
ASSEMBLY
Check Chains - Extra Equipment - for Lift-Models (Figure Asm-0011)
1. Check Chains are available for attachment to
front of Mower as an accessory. Check chains
are used to control cutting height and especially
allow Mower to be lowered to the same preset
cutting height effortlessly.
2. Install lower end of check chain (4) to hitch ears
(6) through lower holes (7) using bolts, nuts and
lockwashers(8). Tighten securely.
3. Install chain lugs (3) on either side of tractor top
link mounting (5) using bolt or pin of required
diameter and length. Cat I kit requires a 3/4"
diameter bolt. Cat II kit requires a 1" diameter
bolt. Install top end of check chains in brackets
(3).
4. Cutting height is then set by placing proper
chain link in keyhole slot. Cutting height is
easily adjustable by hooking chain higher or
lower in the keyholes in chain lug (3).
For additional safety in transport, raise mower as high as possible without having driveline
hit deck and shorten check chains as much as possible to prevent inadvertent falling in
transport.