Filter
Top Products
4, TheMowerSuspensionArmsandFasteners(shownfull
sizebelow)arefoundinBagofParts,
WASHER
LOCKWASHER HEX NUT
____00 _ RETAINING
O CLIP
C
O
BRACKET
RETAINING / WASHER
CLIP •
LIFT LINK
STUD
SUSPENSION
ARM LOCKWASHER
HEX NUT
FIGURE 14
RETAINING CL|P
5. The Mower Suspension Arms have "FRONT" Stamped
between holes. Place the Suspension Arms on Brackets on
both sides of Frame. Retain with Retaining Clip (Fig° 14).
6. Slide Mower under Tractor. Deflector to right hand side..
7. Siide Front Suspension Brackets into Mower Brackets, Re-
tain with Release Pins (Fig= 15). Turn Depth Adjustment
Knob counterclockwise (_) until it stops,
8, Slide Suspens}on Arms into Rear Suspension Brackets=
Retain with Reiease Pins (Fig, 15),
9. Turn Depth Adjustment Knob (Fig. 15) clockwise (/'_)
to remove slack from Mower Suspension. Raise Attachment
Handle to full up position.
10, Press plunger down and push Attachment Handle forward
to lower mower to ground. Roll D'rlve Belt over Primary
Mandrel (Fig. I6),
DEPTH
ADJUSTMENT
KNOB
\.
REAR
SUSPENSION
BRACKETS
RELEASEPIN
ATTACHMENT
HANDLE
MOWER
BRACKET
PiN
FRONT
SUSPENSION
BRACKET
FIGURE 15
PRIMARY
MANDREL
MOWER DRIVE
BELT
FIGURE 16
-9_