Filter
Top Products
NEGATIVE
(BLACK CABLE)
TERMINAL
STARTING YOUR TRACTOR WITN
A LOW BATTERY
if your Battery is too low to start the engine, it should be
recharged. If Jumper Cables" are used for emergency star"_ing
follow this procedure: NOTE: YOUR TRACTOR IS EQUIP-
PED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM,
THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGA,
T1VE GROUNDED SYSTEM.,
LEAD-ACID BATTERIES GENERATE EX-
PLOSIVE GASES. KEEP SPARKS, FLAME,
AND SMOKING MATERIALS AWAY
FROM BATTERIES. ALWAYS WEAR EYE
PROTECTION AROUND BATTERIES,
POSITIVE
(RED CABLE)
TERMINAL
FIGURE 10
1.
2_
3.
4_
Connect each end of the RED cable to the POSITIVE (+)
terminals of each battery (taking care not to short against
chassis)(Fig. 10),
Connect one end of the BLACK cable to the NEGATIVE
(-) terminal of fuIty charged battery°
Connect the other end of the cable to ENGINE BLOCK
or good CHASSIS GROUND on tractor (away from Gas
Tank or Battery},
Disconnect cables in reverse order:
a, Engine Block or chassisof tractor,_
b. Negative terminal of fully charged bat'_ery.
c. Positive terminajso
FIGURE 11
CLUTCH
BRACKET
MOWER
DRIVE
BELT
MOWER AND DRIVE BELT
IN STALLATION
Your tractor has been shipped with the Mower Suspension
Bracket banded to the frame° Remove bands and lower Mower
SuspensionBracket (Fig 11)
DRIVE BELT INSTALLATION
1,, Remove Hood and Grill (seepage 24)°
2.
3_
4.
Place Mower Drive Belt over Clutch PuJley and under Idler
Pulley and Tension Pulley (Fig, 12), NOTE" PULL LEVER
UP TO SWING TENSION PULLEY FOR BELT CLEAR-
ANCE_ Make sure narrow "V" side of Beit isengagedwith
each Pulley,
Pull Mower Drive Belt over Front Mower Suspension Brack-
et (Fig° 13)_
Replace Hood and Grill°
MOWER SUSPENSION
BRACKET
LEVER
TENSION
PUt_,LEY
IDLER PULLEY
MOWER
DRIVE BELT
FIGURE 12 - 8 - FIGURE 13