Filter
Top Products
5o Install Battery using: two Int./Exto Lockwashers, two Wing INTJEXT. WING WING NUT
Nuts {shown full size below) and LOCKWASHER NUT
two Battery Bolts and one Terminal Guard found in Bag of
Parts.
a, Using the square hole on one side of the Battew Support
(Fig, 4") insert one Battery Bolt, head of Bolt down°
Fasten the Battery Bolt to the Terminal Guard using
into/Exto Lockwasher and Wing Nut as shown in Fig. 4.
b. Assemble the remaining Battery Bolt to other side of
Battew Support and fasten Terminal Guard to it with re-
maining lnt./Exto Lockwasher and Wing Nut_ Tighten
Wing Nuts securely by hand (Fig° 4).
NOTE: USE TERMINAL ACCESS DOORS (FIG 4) FOR:
1. Inspection for secure conne_tlons (tighten hardware)..
2. Inspection for corrosion.
3. Testing battery..
4,_ ,Jumping (if required}.
5. Charging {if requiredL
tNTJEXT,
LOCKWASHER
ACCESS
DOOR
TERMINAL
GUARD
TERMINAL
ACCESS DOOR
BATTERY BOLT
BATTERY
SUPPORT
FIGURE 4
HEX WASHER HEAD BOLT
LOCKWASHER
ASHER
WHEN NOT IN USE, KEEP TERMINAL
ACCESS DOORS CLOSED.
DO NOT START ENGINE UNTIL MOWER
SUSPENSION BRACKET HAS BEEN RE-
LEASED° SEE MOWER AND DRIVE BELT
INSTALLATION, PAGE 8.
6. Close Hood.
7. Install Steering Wheel.
NOTE: POSITION FRONT WHEELS FORWARD,
a. Remove Hex Washer Head Bolt, Lockwasher and Large
Washer from Steering Column (Fig_ 5)°
bo Position Steering Wheel over Steering Wheel Insert
c. S_ecure Steering Wheel to Steering Cotumn using Hex
Bolt, Lockwasher and Large Washer (Figr 5).
do Snap Steering Wheel Cap in place on Steering Wheel.
Steering Wheel Cap found in Bag of Parts.
8. To adjust seat position, pivot seat forward. Use 3/4"
wrench to loosen Seat Bolt and stide seat to desired posi-
tion. Make sure seat sets straight on Seat Pan and tighten
Seat Bolt securely (Fig° 6)°
STEERING WHEEL
WHEEL INSERT
STEER,NOCOLUMN
FIGURE 5
-5_
/
SEAT PAN
SEAT BOLT