Filter
Top Products
POSITION
ATTACHMENT
HANDLE
MOWER ADJUSTMENT
Adjust the mower while tractor is parked on level ground or
driveway, Make sure tire pressures are 14 PSI in front; 10
PSI in rear.
FIAIRPIN
CLIP
z1
J
GAUGE
WHEEL CLEVIS
PIN _,
FIGURE 17
SiDE TO SLIDE ADJUSTMENT
1, Use a ruler to make sure Flanges at rear of mower deck
are the same height from the ground on each side (Fig
19).
2. If adjustment is required, snap out Access Cover on LH_
side of tractor above Foot Rest (Fig,, 18),
3o Move Attachment Handle to full '_UPt' position (Fig_ 17).
4. To lower' right side of mower, loosen Nut "B" and screw
Nut "A" down on Adjustment Rod.
5oTo lower left side of mower, loosen Nut "B" and screw
Nut "A I_up on Adjustment Rod.
6oAdjust until both rear mower flanges are the same height
• _] tI IT II
above the ground, T=ghten Nuts A and B securely,
Snap AccessCover in place,
NUT "'A"
©
FRONT TO REAR ADJUSTMENT
Move Attachment Handle to full "UP" position (Fig. 17).
After leveling side to side, measure R.H. Flanges at FRONT
AND REAR OF MOWER° The Roll Front Flange should
measure 3/4" lower than the R.H Rear Flange (Fig t9)
If adjustment is required, follow procedure below
FIGURE 18
FRONT
FLANGE
REAR
FLANGE
FLANGE
FIGURE 19 - 10-