Filter
Top Products
18.
Raise hood and remove 3/8" carriage bolt and
nut from right hand side of frame. See figure 18.
LIFT
LEVER
. PLUNGER
REMOVE FRONT
CARRIAGE BOLT
AND NUT
RIGHT SIDE VIEW
FIGURE 18
!9. Assemble support bracket onto right hand side
of tractor frame (where carriage bolt was
removed in step 15) using 3/8" x 1"" carriage
bolt inside of frame and secure with 3/8" lock
washer and 3/8" hex nut, on outside of frame.
See figure 19.
ATTACHMENT
LIFT LEVER
LIFT LEVER FRONT---_
PLUNGER
BLADE PIVOT
1/4" HEX LOCK ROD
3/8"'x 1"
CARRIAGE EYE BOLT
BOLT HAIRPIN
3/8" LOCK COTTER
WASHER 3/8" HEX NUT
RIGHT SIDE VIEW
FIGURE 19
20. Assemble the 1/4" eye bolt at the top of the
support bracket and secure with one 1/4'" hex
. lock nut. See figure 19.
21. Assemble blade pivot rod through 1/4" eye
bolt as shown in figure 19. Secure lower end
of blade pivot rod through hole on right hand
side of blade assembly with small hairpin
cotter. See figure 19.
22. Assemble blade lock release lever to right side
of tractor frame using one 1-1/2" OD washer,
one 3/8" x 1" hex bolt, spacer, 3/8" flat washer
and secure tightly with one 3/8" hex lock nut.
See figure 20.
23. Secure one end of blade lock release cable to
small hole in blade lock release lever using one
3/8" x 3/4" clevis pin and one 3/32" hairpin
cotter• See figure 20.
BLADE LOCK
RELEASE LEVER
1-1/2" O D WASHER
3/8" x 1"
HEX BOLT
D
CLEVIS PIN
COTTER PIN
FIGURE 20
SPACER
FLAT WASHER
3/8" HEX LOCK NUT
24. Thread cable toward front of tractor under
steering tie rod and front axle and above guide
bracket assembly• See figure 21.
25.
Assemble one 3/8" x 1-1/2" carriage bolt into
top hole in angle lock bars and tighten secure-
ly with one 3/8" hex lock nut. Place free end
of cable over threaded end of carriage bolt and
retain loosely with 3/8" hex lock nut. See figure
21.
RIGHT SIDE VIEW
FRONT .
SUPPORT BRACKET
3/8"" x 1-1/2"' CARRIAGE BOLT
NUTS (2)
il
STEERING
TIE ROD
CHANNEL
ASS'Y.
FREE END
OF CABLE
GUIDE BRACKET
ASS'Y.
FIGURE 21
Q