Filter
Top Products
.
Assemble one lift pivot plate under left hand foot
rest and outside of frame. Secure front of lift
pivot plate with one 3/8" x 1" c_levis pin, 3/8"
flat washer and 3/32" (small) hairpin cotter.
Secure rear of lift pivot plate with one 3/8" x
3/4" clevis pin and one 3/32" (small) hairpin
cotter. DO NOT ASSEMBLE LiFT PIVOT PLATE
UNDER THE RIGHT HAND FOOT REST AT THIS
TIME.
.
Assemble one 3/8" x 1-1/4" hex bolt through
3/8" flat washer, through pivot bushing,
through large hole in lift arm link near angle end
and through hole in long arm nearest the end.
Secure with one 3/8" lock washer and one 3/8"
hex nut. See figure 12. NOTE: Lift arm link must
pivot freely.
•_ FRONT LEFT HAND
SIDE VIEW
FRAI_E _ CLEVIS PIN
,
..... _'.'_ ', _, \_ll FOOT REST
._/_ x ]-" __ _ (LEFT HAND)
-_ _ -"3/8" FLAT WASHER
LIFT PIVOT PLATE _ _,
10.
11.
NOTE
Lift arm link must be positioned as
shown in figures 12 and 13.
Assemble one 3/8" x 1" hex bolt through
second hole from end of long arm. Secure with
one 3/8" lock washer and one 3/8" hex nut.
This bolt is used as a limit stop for the lift arm
link. See figure 13.
Move attachment lift lever all the way forward
and lock in position. See figure 20, page 9.
FIGURE 10
FRONT (L.H.) SIDE VIEW
;T HAND FOOT REST
c_
l=l
3/32" HAIR PIN
COTTERS
LIFT PIVOT PLATE
FIGURE 11
8. Pre-assemble lift arm link to inside of long arm
on lift assembly. As shown in figure 12.
3/8" x 1-1/4"_.=_ 3
HEX BOLT
I.IFT ASSEMBLY
LONG ARM
" FLAT WASHER
_BU PIVOT
SHING
,_LIFT ARM
LINK
\
318" HEX
/
3/8" LOCK WASHER
12.
13.
14.
Hook lift assembly arms over both link rods,
assemble lift arm link over channel rod and
secure with one 1/8" (large) hairpin cotter. See
figure 13.
Assemble one hitch brace (endwiththe large
hole), one 1-1/4" OD spacer onto each end of
the lift assembly pivot shaft. See figure 14.
Insert pivot shaft end (from R.H. side of tractor)
into hole in L.H. lift pivot mount plate. See figure
14.
RIGHT HAND SIDE VIEW
FRONT_
3/8'" x 1" HEX BOLT
3/8" LOCK WASHER
3/8" HEX NUT
LIFT ARM LINK
CHANNEL
ROD
SHAFT END
LIFT
LIFT PIVOT MOUNT PLATE
\
HAIRPIN
COTTER
FIGURE 12 FIGURE 13
.