Filter
Top Products
You can adjust the drive speed and direction using the drive speed control lever. Be
sure to release both the auger control handle and the drive control handle before
adjusting the drive speed control lever.
As you use the snow thrower, you may want to adjust the chute outlet direction. Be
sure to release both the auger control handle and the drive control handle before
adjusting the chute outlet direction.
Figure 11- Adjusting Chute Outlet Direction Figure 12- Adjusting Drive Speed and Direction
CHUTE DEFLECTOR
The angle of the chute deflector controls the throwing distance of the snow leaving the
chute. Raising the angle will increase the throwing distance. Lowering the angle will
decrease the throwing distance (see figure 13).
To adjust the chute deflector:
1. Make sure the engine is stopped and the auger and impeller have come to a full
stop.
2. Loosen the knobs on the chute deflector as shown in figure 13 and adjust the
chute deflector to the desired angle.
3. Re-tighten the knobs on the chute deflector. Do not over-tighten.
increase
throwing_
distance_1_
decrease
throwing
distance
ustment
Figure 13- Adjusting the chute deflector
18