Filter
Top Products
Chute Rotation Handle
To attach the chute rotation handle:
1. Remove the handle grip from the handle by removing the screw at the end (see
figure 4).
2. Slide the end of the chute rotation handle, with the grip removed, through the eye
hole on the snow thrower handle as shown in figure 4 a.
3. Slide the other end of the chute rotation handle through the hole near the base of
the chute. Line the spiral of the handle up with the grooves in the base of the
chute (see figure 4b)..
4. Insert the fastener pin through the end of the chute rotation handle near the chute.
Bend the ends of the pin to hold the pin in place.
5. Reattach the grip to the chute rotation handle.
HOLE
HANDLE
_DLE GRIP
b
Figure 4- Chute Rotation Handle Assembly
Drive Control and Auger Control ('able Assembly
The cables that control the drive and auger are already attached to the snow thrower. To
connect them to their respective handles:
1. Attach the cable hooks to the holes on the inner portion of the drive control and
auger control handles as shown in figure 5a. The hook should dangle freely from
the handles.
2. Connect the drive control and auger control cables to the cable hooks using the
attached turnbuckles (see figure 5b). Rotate the turnbuckles to tighten. The
cables should be just barely taut when the drive and auger control handles are in
the raised position.
11