Sears 247.7764 Log Splitter User Manual


  Open as PDF
of 60
 
13
OPERATION
7. Attempt to cut wood across the grain.
8. Attempt to remove partially split wood from the wedge with your
hands. Fully retract the wedge to dislodge the wood with the log
dislodger.
TRANSPORTING THE LOG SPLITTER
IMPORTANT: Always turn the fuel valve to the OFF position before
transporting the log splitter.
1. Lower the beam to its horizontal position. Make certain the beam is
locked securely with the horizontal beam lock.
2. Removespringclipandclevispinfromjackstand.
3. Supportthetongueandpivotthejackstandupagainstthetongue.
See Figure 4-5.
4. Securethejackwiththespringclipandclevispinpreviously
removed. See Figure 4-5.
5. Attach the coupler hitch to a class I or higher 2” ball on a towing
vehicle. Latch securely.
a. If the coupler hitch does not fit on the ball:Turntheadjust-
ment nut one turn counter-clockwise.
b. If the coupler hitch is too loose on the ball:Turntheadjust-
ment nut one turn clockwise.
6. Connect the safety chains to the towing vehicle.
7. Plug in the tail lights, if so equipped, to the tail light connector on
the tow vehicle.
WARNING
Do not tow faster than 45 mph and check local, state, and federal
requirements before towing on any public road.
NOTE: Use caution when backing up. Using a spotter outside of the
vehicle is recommended.
2. Stand behind the reservoir tank to operate the control handle and to
stabilize the log. See Figure 4-4.
Operating Tips
Always:
1. Use clean fluid and check the fluid level regularly.
2. Useanapprovedhydraulicfluid.ApprovedfluidsincludeDexron®
III / Mercon® automatic transmission fluid or a 10 Weight AW
hydraulic oil.
3. Use a filter (clean or replace regularly).
4. Use a breather cap on the fluid reservoir.
5. Make sure the pump is mounted and aligned properly.
6. Useaflexible“spider”typecouplingbetweentheengineandpump
drive shafts.
7. Keep the hoses clear and unblocked.
8. Bleed the air out of the hoses before operating.
9. Flush and clean the hydraulic system before restarting after servic-
ing.
10. Use “pipe dope” on all hydraulic fittings.
11. Allow time for the engine to warm-up before splitting wood.
12. Prime the pump before the initial start-up by turning over the engine
with spark plug disconnected.
13. Split the wood along the grain (lengthwise) only.
Never:
1. Use when fluid is below 20° F or above 150° F.
2. Use a solid engine /pump coupling.
3. Operate through the relief valve for long.
4. Attempttoadjustunloadingorreliefvalvesettingswithoutpressure
gauges.
5. Operate with air in the hydraulic system.
6. Use teflon tape on the hydraulic fittings.
Figure 4-5
Figure 4-4
 previous next