Filter
Top Products
Service Electrical - Page 38
SERVICE ELECTRICAL
2. Connect positive (+) charger cable to positive (+) battery
terminal.
3. Connect negative (–) charger cable to negative (–)
battery terminal.
4. Plug in charger cord.
5. Charge battery using a 12 Volt battery charger at a rate
of 6–10 amperes for a minimum of 1 hour and no more than
2 hours.
6. Unplug charger cord. Remove charger cables.
7. Install battery. (See Removing and Installing Battery in
this section.)
Using Booster Battery
1. Connect positive (+) booster cable to booster battery
positive (+) post (D).
2. Connect the other end of positive (+) booster cable to
vehicle battery positive (+) post (A).
3. Connect negative (–) booster cable to booster battery
negative (–) post (C).
4. Connect the other end of negative (–) booster cable (B)
to engine ground away from battery.
Replacing Headlight Bulb
1. Lift hood.
2. Push in and turn bulb socket (A) 1/4 turn
counterclockwise to remove.
3. Replace defective bulb with a new bulb.
4. Insert bulb socket into housing, push in and turn 1/4 turn
clockwise to install.
5. Lower hood.
c CAUTION: Avoid injury. Battery gas is
explosive:
- DO NOT smoke while you charge battery.
- Keep all flames and sparks away.
- DO NOT charge frozen battery.
- DO NOT connect booster battery negative (-)
cable to starting vehicle negative (-) terminal.
BOOSTER
BATTERY
VEHICLE
BATTERY
TO ENGINE
GROUND
A
C
B
D
M88559
A