Filter
Top Products
4)
5)
Install the rear cover to fit the rotor bearing.
Lightly strike the circumference of the rear cover
evenly with a plastic hammer. (See Fig. 1 O-23 .)
NOTE: Be careful not to pinch the wires between
the stator and rear cover.
Fig. lo-23
Tighten the cover bolt.
NOTE: The bolt cannot be tightetied unless the front cover and rearcover are positioned correcdy.
The shape of the cover bolt is shown below.
MODEL
d I
S
RGX305
6mm 130 mm
25
mm
I
RGX305D i 0.24 inch
j
5.12 inch 0.98 inch
RGX405 1 8mm 135 mm
25
mm
RGX405D - 0.31 inch 5.31 inch : 0.98 inch
RGX505
8mm I 155mm (
35
mm
RGX505D I 0.31 inch
i
,
6.10 inch i 1.38 inch
6) Install the stator cover.
+RGX305, RGX305D
Fit the stator cover between the stator and cover
bolts until it covers all the cover bolts, and fold
back the edge.
*RGX405, RGX405D and RGX505, RGX505D
Fit the stator cover all the entire cover bolts, and
fold back the edge.
7) Pass the wires
out
of the top of rear cover through
the grommet, and fit the grommet into the hole in
the rear cover. (See Fig. 10-24.)
Table 10-4
Fig. lo-24
-53-