Filter
Top Products
10. DISASSEMBLY and REASSEMBLY
10-I PREPARATIONS and SUGGESTIONS
1)
Wren disassembling the engine, remember well the locations of individual parts so that they can be reassembled correct-
ly. If you are uncertain of identifying some parts, it is suggested that tags be attached to them.
2)
Have boxes ready to keep disassembled parts by group.
3)
To prevent missing and misplacing, temporarily assemble each group of disassembled parts.
4)
Use the correct tools in the correct way.
10-2 HOW TO DISASSEMBLE
Order 1
Item
Procedure
I
Remarks
I
Tool
1 , Fuel Tank
( 1) Remove the front panel. (See Fig. lo- 1.)
Be careful not to cut the
1 (+) screwdriver
!
Remove the screws, and suspend the
wiling.
i
control box front panel with a wire.
I
4$ screw . . . 6 PCS.
I (2) Remove the strainer bracket (See Fig.
I
i ’ 8 mm spanner
I
10-2.)
Remove the strainer bracket bolts on
the bottom of the control box.
54 bolt . _ . 2 PCS.
I
(3) Temporarily f&ten the front panel.
1 Be careful not to pinch
(+) screwdriver
Temporarily fasten it with two or
the wiring.
three screws removed in Step (1).
:
(4) Remove the rubber pipe.
i If fuel spills out from the ’ Rliers
(See Fig. 10-3.)
fuel pipe, wipe it off.
Turn the fuel cock off, remove the
clamp from the strainer on the carbu-
retor side of the fuel pipe, and remove
I
the fuel pipe.
I
[ (5) Remove the fuel tank bolts.
(See Fig. 10-4.)
89 bolt. . . 4 PCS.
(6) Remove the fuel tank.
I
13 mm spanner or
I
1 box spanner
I
Be careful not to lose the
[
rubber washers located
*
between the fuel tank
I and tank mounting side
i plates.
Fig. lo- 1
Fig. 10-2
-43-