Filter
Top Products
34
■ STARTING ENGINE
The cutting head will start rotating upon the engine
starts.
1. Feed fuel and chain oil into their respective tanks
and tighten the caps securely. (OP1)
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
3. Push the primer pump several times until overflown
fuel flows out in the clear tube. (OP2)
4. Move the choke lever to the closed position. (OP3)
(1) Choke lever
(2) Close
(3) Open
5. Set the ignition switch to the “Start” position. While
pulling the throttle lever, push the throttle set button,
and release the throttle, then the throttle lever is in to
the “Start position”. (OP4)
(1) Start
(2) Stop
(3) Ignition switch
(4) Throttle lever
(5) Throttle set button
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP5)
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever downward to open the choke.
And restart the engine. (OP3)
8. Allow the engine to warm up for a several minutes
before starting operation.
IMPORTANT
WARNING
OP2
OP1
(1)
(2)
(3)
OP3
(3)
(4)
(5)
(1)
(2)
OP4
OP5
8. Operation
English