Filter
Top Products
30
8. Push the choke knob in to the RUN position.
When restarting immediately after stopping the engine,
set the Choke knob in the RUN position (choke open
and throttle lever in the starting position).
Keep clear of the saw chain as it will start rotatIng
upon starting of engine.
■ CHECKING THE OIL SUPPLY
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is very
dangerous.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown in
the figure. (F8-6)
(1) Chain oil
The oil tank should become nearly empty by the time
fuel is used up. Be sure to refill the oil tank every time
when refueling the saw.
■ ADJUSTING THE CARBURETOR
The carburetor on your unit has been factory adjusted,
but may require fine tuning due to a change in
operating conditions.
Before adjusting the carburetor, make sure that the
provided air/fuel filters are clean and fresh and the fuel
properly mixed.
When adjusting, take the following steps:
Be sure to adjust the carburetor with the bar chain
attached.
NOTE
NOTE
WARNING
WARNING
NOTE
F8-6
8. Operation
English