Filter
Top Products
28
It is very dangerous to run a chain saw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
■ STARTING THE ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F8-1)
2. Set the switch to “I” position. (F8-2)
(1) Chain oil
(2) Fuel
(3) Switch
3. Continuously push the primer until fuel comes in the
bulb. (F8-3)
(4) Primer
4. Pull the choke knob all the way out to FULL CHOKE
position. (F8-4)
(5) Choke knob (FULL CHOKE Position)
(a) RUN (b) HALF CHOKE (c) FULL CHOKE
5. While holding the saw unit securely on the ground,
pull the starter grip until the engine attempts to start,
but no more than 5 times. (F8-5)
Do not start the engine while the chain saw hangs
in one hand. The saw chain may touch your body.
This in very dangerous.
6. Push the choke knob to HALF CHOKE position.
7. Pull starter grip until engine runs.
Allow the saw to run in this position 15~30 seconds,
depending upon the temperature.
NOTE
WARNING
WARNING
(5)
(a)
(b)
(c)
(4)
F8-1
F8-2
F8-3
F8-4
F8-5
8. Operation
English