Filter
Top Products
January 28, 2008
Page 33
Quadra-Fire · Sapphire · 250-7233E
F. Hearth Legs Installation
Refer to Section 12 for specific color part numbers.
Hearth legs will allow three additional inches of clearance.
Be sure to calculate this distance correctly if necessary to
cut wall hole to install horizontally. Refer to Dimensions on
in Section 12.
To change legs, use a 1/2 in. wrench to remove and replace
one leg at a time while the appliance is in an upright
position.
G. Positioning the Logs
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE: Logs have been designed to work
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
Figure 8.18 The log set is packed in the components box and
consists of the following:
1
2
3
4
5
Figure 8.19 Set the rear log on the three locator pins in the
back of the fi rebox.
Figure 8.20 Set left and right partial logs (with butt end towards
the side of the appliance fi rebox) in the grooves provided on
the burner surface.
Locate the pin hole on the bottom of the right and left twigs
and situate them over the white pins, one is located on the
rear log and the other is on the right partial log.
Qty. Description #
1 Rear Log 1
1 Left Partial Log 2
1 Right Partial Log 3
1 Left Twig 4
1 Right Twig 5
NOTE: HEARTH LEGS CANNOT BE USED IF A
BLOWER IS INSTALLED AS THERE WILL NOT BE
ENOUGH CLEARANCE.