Filter
Top Products
12 1-800-732-2677
4. Check the tightness of the Receiver Collar by inserting one
finger between the end of a Contact Point and your pet’s
neck. The fit should be snug but not constricting (9B).
5. Allow your pet to wear the collar for several minutes then
recheck the fit. Check the fit again as your pet becomes
more comfortable with the Receiver Collar.
6. Once you are satisfied with the fit of the Receiver Collar
then you may trim any excess collar strap as follows (9C):
a. Mark the desired length of the Receiver Collar with a
pen. Allow for growth if your pet is young or grows a
thick winter coat.
b. Remove the Receiver Collar from your pet and cut off
the excess.
c. Before placing the Receiver Collar back onto your pet,
seal the edge of the cut collar by applying a flame along
the frayed edge.
9B
9C
Important: For comfort, safety and effectiveness of product, please ensure the following:
• During the fi rst 2 weeks of training, do not use the training device on your pet without direct supervision.
• Check the fi t of the Receiver Collar to prevent excessive pressure. You should be able to insert one
fi nger between the Contact Point and your pet’s skin.
• Never leave the Receiver Collar on your pet for more than 12 consecutive hours.
• Your pet must be carefully examined daily for any signs of a rash or sore.
• If a rash or sore is observed, discontinue the use of the Receiver Collar for a few days.
• If the condition persists beyond 48 hours, see your veterinarian.
• Your dog’s neck and the Contact Points must be washed weekly with a wash cloth and mild hand soap,
then rinsed thoroughly.
A condition called Pressure Necrosis, which is a devitalization of the skin due to excessive and prolonged
contact against the Contact Points, may occur if the steps above are not followed.
To Re-Thread the Collar
Slide Buckle
Ridges
The slide buckle prevents the collar from becoming loose
around your pet’s neck.
The ridges must be facing up; the collar will slip if it is not
properly threaded.