Filter
Top Products
18
TROUBLE CAUSE REMEDY
Engine will not
start.
1. ON/OFF switch in OFF
position.
2. Engine flooded.
3. Fuel tank empty .
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
6. Carburetor requires
adjustment.
1. Move ON/OFF switch to ON position.
2. See “Starting a Flooded Engine” in
Operation Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair o r replace.
6. Contact an authorized service dealer.
Engine will
not idle
properly.
1. Carburetor requires
adjustment.
2. Crankshaft seals worn.
3. Compression low.
1. See “Carburetor Adjustment” in
Service and Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1. Air filter dirty .
2. Spark plug fouled.
3. Carburetor requires
adjustment.
4. Carbon build-up on
muffler outlet screen.
5. Compression low.
Engine will not
accelerate,
lacks power,
or dies under
a load.
1. Clean or replace air filter .
2. Clean or replace plug
and regap.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
Engine
smokes
excessively.
1. Choke partially on.
2. Fuel mixture incorrect.
3. Air filter dirty.
4. Carburetor requires
adjustment.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter .
4. Contact an authorized service dealer.
Engine runs
hot.
1. Fuel mixture incorrect.
2. Spark plug incorrect.
3. Carburetor requires
adjustment.
4. Carbon build-up on
muffler outlet screen.
1. Empty fuel tank and refill with
correct fuel mixture.
2. Replace with correct spark p lug.
3. Contact an authorized service dealer.
4. Contact an authorized service dealer.
WARNING: A lwaysstopunitand disconnectspark plugbeforeperformingallofthe
recommended remedies below except remedies that require operation of the unit.
TROUBLESHOOTING TABLE
DECLARATION OF C ONFORMITY
relating to 2000/14/EC
EC Declaration of Conformity relating to 2000/14/EC
We, Electrolux Home Products, Inc., Texarkana, TX, 75501, USA, Tél. : +1 903 223
4100, declare under sole responsibility that the Partnermodel T330+brushcutter was
assessed in accordance with Annex V of the DIRECTIVE and from serial numbers
2005--335N00001 and onw ards, conforms to the provisions of the DIRECTIVE. The
cuttingwidthis 431mm. The measuredsound poweris 108dB andthe guaranteed sound
power is 1 14 dB.
Texarkana 05--12--01
Michael S. Bounds, Director
Product Safety and Standards