Filter
Top Products
GLOBUG LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/23/09) — PAGE 19
SETUP
GBS SETUP
Attach one of the clamps that come with the GBS to the 1.
external support pole. The clamps may be attached to
vertical, horizontal, or angled pole. See Figure 11.
Clamp AttachmentFigure 11.
Using a 19 mm wrench, tighten the locknut securely. 2.
See Figure 11.
Attach the other clamp to the external support pole 3.
about 7 inches (140 mm) lower than the previously
installed clamp. See Figure 12. If using horizontal
external support poles, a second pole is needed.
Distance Between ClampsFigure 12.
LOCKNUT
LOCKNUT
VERTICAL
EXTERNAL
SUPPORT
POLE
ANGLED
EXTERNAL
SUPPORT
POLE
CLAMP
CLAMP
HORIZONTAL
EXTERNAL
SUPPORT
POLE
7.0 INCHES
(140 MM)
Attach the straight pole to the clamps. Tighten locknuts 4.
on both clamps. See Figure 13.
Straight Pole AttachmentFigure 13.
Place the offset pole (or an optional straight pole, if 5.
desired) on top of the straight pole. Tighten knob or
bolt securely. See Figure 14.
Offset Pole AttachmentFigure 14.
CLAMPS
STRAIGHT
POLE
WARNING
Always securely tighten the locknuts when assembly
is used to prevent the lighting system from falling off
which can cause injury or equipment damage.
STRAIGHT
POLE
OFFSET
POLE
KNOB
BOLT
WARNING
Always securely tighten the knob on the offset or the
bolt on the straight pole when assembly is used to
prevent the lighting system from falling off which can
cause injury or equipment damage.