Filter
Top Products
DCA-400SSK — PARTS AND OPERATION MANUAL (STD)— REV. #3 (09/17/01) — PAGE 37
How to read the output terminal gauges.
The gauges and knobs on the control panel DO NOT effect
the generator output in any fashion. They are there to
simply help the operator observe how much power is being
supplied produced at the UVWO legs.
To read the output of the W-U legs, for example, place the
AC Voltmeter Change-over switch to the W-U position and
the AC ammeter Change -over Switch to the U or W
position to read the output on the selected leg.
FIGURE 15. AC Voltmeter
Change-over switch
(Reading the W-U leg on
the output terminal panel)
FIGURE 18. AC Ammeter
(Amp reading on U lug)
FIGURE 17. AC Ammeter
Change-over Switch
(Reading the U leg on the
output terminal panel)
FIGURE 16. AC Voltmeter
Gauge
(Volt reading on W-U Lug)
DCA-400SSK — OUTPUT TERMINAL PANEL OVERVIEW