Filter
Top Products
PAGE 28 — DCA-300SSK SERIES — PARTS AND OPERATION MANUAL (STD) — REV. #4 (03/27/06)
Generator Output Voltages
A wide range of voltages are available to supply voltage for
many different applications. Voltages are selected by apply-
ing jumpers (6) to the
voltage change-over board
(Figure 14).
To obtain some of the voltages as listed in Table 7 (see
below) will require a fine adjustment using the
voltage regu-
lator
(VR)
control knob
located on the control panel.
Voltage Change-Over Board
The
voltage change-over board
(Figure 14) is located on
the control box, behind the generator control panel. This
board has been provided for ease of voltage selection.
Figure 14. Voltage Change-Over Board
240V Configuration
DCA-300SSK SERIES — GENERATOR OUTPUTS
Generator Amperage
Tables 8 and 9 describe the generator’s current output capa-
bility for both 1Ø-phase and 3Ø phase applications.
segatloVelbaliavArotareneG.7elbaT
esahP-eerhT
V802V022V042V614V044V084
esahP-elgniS
V021V721V931V042V452V772
sgnitaRerepmArotareneG.8elbaT
⎯⎯
⎯
⎯⎯
1
∅∅
∅
∅∅
WkV931V042V772V084
02441382724
0488276144138
06234052712521
08675333982761
001917714163802
021368005334052
0417001385505292
0611511766875333
081592
1057056573
0029341338227714
0223851719497854
)xaM(04272710001668005
sgnitaRerepmArotareneG.9elbaT
⎯⎯
⎯
⎯⎯
3
∅∅
∅
∅∅
WKV042V084
020603
0402106
0608109
08142021
001103051
021163081
041124012
061184142
081145172
002106103
022266133
042227163
CAUTION - CHANGING VOLTAGES
NEVER attempt to place jumper plates on the
voltage
change-over board
while the generator is in operation.
There exist the possibility of
electrocution, electrical
shock or burn, which can cause severe bodily harm
or even death
!