Filter
Top Products
10
Attaching Discharge
Chute
On Older Model Riders
1. On some older models, a clip is already installed on
the cutting deck next to the discharge chute opening
in position A, B, or C, as seen in Figure 21. If this
is the case, the clip must be removed and a grass
catcher pin installed.
2. Pin Installation: A grass catcher pin (G in Figure
4) and nut (H in Figure 4) have been supplied in
the hardware pack. First remove the clip, as seen
in Figure 22A, by removing the nut and bolt. Then
attach the grass catcher pin as seen in Figure 22B.
Make sure to secure the pin tightly.
3. Some units may not have clip, but will have an open
hole for pin installation. In this case, install the grass
catcher pin from the hardware pack in the available
hole.
4. You will then need to position the retainer strap on
the discharge chute to correspond with the hole and
pin. See Figure 23 for retainer strap positioning.
NOTE: The retainer strap is fitted at position A on the
discharge chute. However, on older models of trac
-
tors, you will have to change the position of the strap
depending on the location of the grass catcher pin on
the deck. Remove the retainer strap from position A on
the discharge chute to position B or C corresponding to
the position of the grass catcher pin at A, B or C on the
deck. See Figure 23.
Figure 21
Figure 23
5
Attaching
Discharge
Chute
All 600 Model Series
600 through 699
NOTE:
The retainer strap is
fitted at position A on
the discharge chute.
However, on older models
of tractors, you will have
to change the position of
the strap depending on
the location of the grass
catcher pin on the deck.
Remove the retainer strap
from position A on the
discharge chute to posi-
tion B or C corresponding
to the position of the
grass catcher pin at A,
B or C on the deck. See
Figure 23.
Figure 22
A
B
Discharge Chute