Filter
Top Products
17
Changing Friction Wheel Rubber
The rubber on the friction wheel is subject to wear and
should be checked after the first 25 hours of operation,
and periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
• Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
• Tip the snow thrower up and forward, so that it rests
on the housing.
• Remove six screws from the frame cover
underneath the snow thrower.
• Remove the left wheel from the axle.
• Using a 7/8” wrench, hold the hex shaft and remove
the hex bolts and cupped washer and bearing from
left side of the frame. Refer to Figure 14.
• Holding the friction wheel assembly, slide the hex
shaft out of the left side of the unit. The spacer on
the right side of the hex shaft will fall and the
sprocket should remain hanging lose in the chain.
See Figure 24.
Figure 24
• Lift the friction wheel assembly out between the
axle shaft and the drive shaft assemblies.
• Remove four screws securing the friction wheel
rubber between the friction wheel plates. See
Figure 25. Discard old rubber.
• Reassemble the new friction wheel rubber to the
friction wheel assembly, tightening the four screws
in rotation and with equal force. SeeFigure 25. It is
important to assemble the rubber on the friction
wheel symmetrically for proper functioning.
• Insert the pin from the shift arm assembly into the
friction wheel assembly and hold assembly in
position. Refer to Figure 24.
Figure 25
• Slide the hex shaft through the left side of the
housing and through the friction wheel assembly.
• Insert the hex shaft through the sprocket and the
spacer. Make certain that the chain engages both
the large and the small sprocket.
NOTE: If the sprocket fell from the snow thrower while
removing the hex shaft, place the sprocket on the hex
shaft. Position the hex hub of the sprocket toward the
friction wheel when sliding the sprocket on to the hex
shaft. See Figure 26.
.
Figure 26
• Secure with the cupped washer and hex bolt
removed earlier.
• Secure the frame cover with six self-tapping
screws. Put the snow thrower down to its normal
operating position.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it.
Drive Cover
Shift Arm
Assembly
Pin
Friction
Wheel
Sprocket
Spacer
Shift Arm Assembly
Pin
Sprocket
Spacer
Friction Wheel
Plates
Screws
Friction Wheel Rubber
Hub
Bearing
Shift Arm
Assembly
Pin
Friction
Wheel
Sprocket
Spacer
Sprocket
Hex Hub
of Sprocket
Hex
Shaft
Spacer