Filter
Top Products
5
SECTION 2: CONTENTS OF HARDWARE PACK
Lay out the hardware according to the illustration below for identification purposes. Part numbers are shown in
parentheses. (Hardware pack may contain extra items which are not used on your unit.)
NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign
object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and
nuts are provided for your convenience. Store in a safe place until needed.
A
B
C
E
F
H
G
D
ATTACHING THE HANDLES
Hex Bolts
710-3259 (2)
Hex Bolts
710-1880 (2)
ATTACHING CLUTCH GRIPS
Lock Washers
736-0119 (4)
Saddle
784-5599 (2)
ATTACHING HANDLE PANEL
Carriage Bolts
710-0262 (4)
Hex Patch Nuts
712-3068 (4)
Lock Washers
736-0119 (4)
ATTACHING SPEED SELECTOR PLATE
Self-Tapping Screws
710-0599 (4)
Hex Bolts
710-3015 (2)
Hex Lock Nuts
712-3027 (2)
ATTACHING CONTROL CABLES
Z Fitting
746-0778 (2)
Hex Nuts
712-0121 (2)
ATTACHING CHUTE ASSEMBLY
Hex Bolts
710-3015 (2)
Hex Lock Nuts
712-3027 (6)
Chute Flange Keepers
731-0851 (3) Not Shown
ATTACHING CHUTE DIRECTIONAL CONTROL
Flat Washers
736-0185 (2)
Cupped Washer
736-0242
Hex Nuts
712-3010 (2)
Hairpin Clip
714-0104
Hex Lock Nuts
712-0429 (2)
REPLACEMENT SHEAR BOLTS
Hex Bolts
710-0890A (2)
(Z Fittings might be already attached to cables)
Hex Lock Nut
712-0429 (2)
Spacer
750-1032 (2)
Hex Cap Screw
710-3103 (2)
(No Picture)
(No Picture)