Filter
Top Products
4 5
The grounding prong in the plug is con-
nected through the green wire inside the
cord to the grounding system in the tool.
The green wire in the cord must be the
only wire connected to the tool's ground-
ing system and must never be attached to
an electrically live terminal.
Your tool must be plugged into an appro-
priate outlet, properly installed and
grounded in accordance with all codes and
ordinances. The plug and outlet should look
like those in Figure A.
Double Insulated Tools:
Tools with Two Prong Plugs
Tools marked Double Insulated do not re-
quire grounding. They have a special
double insulation system which satisfies
OSHA requirements and complies with the
applicable standards of Underwriters Labo-
ratories, Inc., the Canadian Standard As-
sociation and the National Electrical Code.
Double Insulated tools may be used in ei-
ther of the 120 volt outlets shown in
Figures B and C.
Grounded Tools:
Tools with Three Prong Plugs
Tools marked Grounding Required have
a three wire cord and three prong ground-
ing plug. The plug must be connected to a
properly grounded outlet (See Figure A). If
the tool should electrically malfunction or
break down, grounding provides a low re-
sistance path to carry electricity away from
the user, reducing the risk of electric shock.
Fig. B
Fig. C
Fig. A
Improperly connecting the
grounding wire can result in the
risk of electric shock. Check with
a qualified electrician if you are in
doubt as to whether the outlet is
properly grounded. Do not modify
the plug provided with the tool.
Never remove the grounding
prong from the plug. Do not use
the tool if the cord or plug is dam-
aged. If damaged, have it repaired
by a MILWAUKEE service facility
before use. If the plug will not fit
the outlet, have a proper outlet
installed by a qualified electrician.
GROUNDING
WARNING!
FUNCTIONAL DESCRIPTION
1. Cord
2. Rear handle
3. Switch
4. Front handle
5. Hand guard / brake lever
6. Guide bar
7. Nose of guide bar
1
2
4
3
5
6
8
11
9
13
12
10
7
8. Saw chain
9. Sprocket cover
10. Sprocket cover nut and washers
11. Drive sprocket
12. Oil tank cap
13. Chain tension adjusting screw
Amperes
Double Insulated
Symbology
Underwriters
Laboratories, Inc.
Volts Alternating Current
FPM
Feet per minute
Chain Speed
1800 ft./min.
549 m/min.
Volts
AC
120
Cat.
No.
6215
Specifications
Amps
13
Guide
Bar Size
16"
406 mm
Oil Tank
Capacity
6 1/2 oz.
190 ml
Chain
Type
3/8" Pitch
Chain