Filter
Top Products
QUICK-START GUIDE
2
Make sure that the computer control panel power switch
(
F) is in the OFF position. Remove the Autostar
®
handbox
and the coiled cord from the packing materials. Plug one
end of the cord into the HBX port (
G).
Tighten (to a "firm feel" only, do not overtighten) the vertical lock
(
I) and the horizontal lock (J).
See page 7 and 8 for more infor-
mation.
...and the other end of the coiled cord into the coiled cord
port at the bottom of Autostar handbox (
H), as shown above.
Place the 26mm eyepiece (C) into the eyepiece holder on
the telescope and tighten the attachment thumbscrew (D) to
a "firm feel" only. See page 7, for more information.
Remove the dust cover (E) from the end of the telescope
tube.
Ả
ả
ầ
Ẩ
ẩ
ấ
Ấ
ạ
Ạ
ấ
Ầ
C
B
D
Remove the ETX
®
telescope from its packaging and place
it on a sturdy surface. Place the ETX on its side and
remove the battery compartment cover (
A) from the under-
side of the drive base. Insert eight (user-supplied) AA-size
batteries into the battery compartment (
B) oriented as
shown in the battery compartment. Replace the cover and
return the telescope to an upright position (if you wish to
attach the telescope to the deluxe field tripod, see page
12).
Flip the Power Switch (F) on the computer control panel to
the ON position. A copyright message lights on Autostar’s
LCD display, followed by a warning not to look at the Sun.
Press the Autostar key prompted by the message when you
are done reading.
A “Getting Started” message displays. Press ENTER to skip
this message.
See pages 9 to 11 for more information about Autostar’s
keys.
This Quick Start Guide demonstrates how to install the batteries and eyepiece, and how to observe using the Autostar Arrow keys.
If you wish to try out Autostar’s “Go To” capabilities, check out the list of page references at the bottom of the following page.
4