Filter
Top Products
-- 9 --
OPERATION
instructions printed on oil container. Once oil is
added topetrol, shakecontainer momentarily to
assurethatthefuelis thoroughly mixed.Always
read and follow the safety rules relating to fuel
before fueling your unit.
MIXING RATIO
Petrol, litre Two--stroke oil, litre
40:1 (2,5%)
2 0,050
5 0,125
10 0,250
CAUTION: Neverusestraightpetrolinyour
unit. This will cause permanent engine
damage.
FUEL REQUIREMENTS
Use good quality unleadedpetrol. Thelowest
recommended octane grade is 90 (RON).
IMPORTANT
Use of alcohol blended fuels (more than 10%
alcohol) can cause major engine performance
and durability problems.
WARNING: Incorrect use of fuel and/
or lubricants will cause problems such as:
improper clutch engagements, overheat-
ing, vapor lock,power loss, lubricationdefi-
ciency, deterioration of fuel lines, gaskets
and internal carburetor components, etc.
Alcohol blended fuels will cause a high ab-
sorption of moisture in the fuel/oil mixture,
causing the separation of oil and fuel.
HOW TO STOP YOUR ENGINE
S Release the throttle trigger.
S Push and hold the STOP switch in the
STOP position until the engine stops.
BEFORE STARTING THE ENGINE
WARNING: YouMUSTmakesure the
tubes are secure before using the unit.
D Fuel engine. Move at least 3 meters away
from the fueling site.
D Hold the unit in the starting position as
shown. Make sure the blower end is di-
rected away from people, animals, glass,
and solid objects.
Blower
Vacuum
STARTING POSITION
WARNING: When starting engine,
hold the unit as illustrated. Do not set unit on
any surface except a clean, hard area when
startingengineorwhileengineis running.De-
bris such as gravel, sand, dust, grass, etc.
could be picked up by the air intake and
thrown out through the discharge opening,
damagingtheunitorproperty,or causingseri-
ous injury to bystanders or the operator.
STARTING A COLD ENGINE (or a
warm engine after running out of fuel)
1. Move the throttle position lever to the idle
position.
Throttle
Position
Lever
2. Slowly press the primer bulb 6 times.
3. Move the start lever to the START position.
Start
Lever
Starter
Handle
Primer
Bulb