Filter
Top Products
C-1
ACCESSORIES
C-1
OPTIONS/ACCESSORIES
LINCOLN ELECTRIC ACCESSORIES
The following options/accessories are available for
your POWER-ARC 4000 from your local Lincoln
Distributor.
Accessory Set (K875) – Includes the following:
• Twenty feet (6.1 meters) of #6 AWG electrode
cable
• Fifteen feet (4.6 meters) of #6 work cable
• Headshield with No. 10 filter
• Work clamp
• Insulated electrode holder
• Sample electrodes
The cables are rated at 150 amps, 40% duty cycle.
Power Plug Kit (K802U) – Provides three plugs, two
for the 120 volt duplex receptacle and one for the 240
volt receptacle. (Order K802T power plug kit for CSA
model)
GFCI Receptacle Kit (K896-3) - Includes one UL
approved 115 volt ground fault circuit interrupter
duplex type receptacle with cover and installation
instructions. Replaces the factory installed 115 volt
duplex receptacle. Each side of the GFCI duplex is
rated at 15 amps but the maximum total current from
the GFCI duplex is limited to 20 amps. (15 Amps for
CSA model)
Undercarriage (K882-2) - 2- wheeled, hand movable
undercarriage available for field installation.
Rotor Removal Kit (S20925) – A service kit with thru
and impact bolts for removing the generator rotor
from the tapered engine crankshaft.
BRIGGS AND STRATTON ACCESSORIES
(FOR THE 8 HP KOOL BORE ENGINE ONLY)
The following options/accessories are available for
your POWER-ARC 4000 from your local Briggs &
Stratton Distributor. Check with the distributor for
availability of options/accessories for the 9 HP
Vanguard engine.
Foam Pre-cleaner (B&S No. 492889) - Provides a
foam pre-cleaner for placement around the paper
cartridge air cleaner. Increases protection in extreme-
ly dusty or dirty environments.
Oil Gard
®
Low Oil Shutdown Kit (B&S No. 398182) –
Installs in the crankcase access port. Senses low oil
conditions and automatically stops the engine. The
engine cannot be restarted until sufficient oil is
added. It is recommended that the Oil Gard Kit be
installed on Power Arc machines where the machine
is subject to long periods of continuous running.
Super Lo-Tone
®
Muffler - Square (B&S No. 494221)
– Replaces the round Lo-Tone muffler that comes
installed on the engine. Limits exhaust noise but
reduces maximum generator output by 100-200
watts.
Muffler Guard (B&S No. 494868) - This guard installs
onto the muffler via a supplied bracket and protects
against incidental contact with a “HOT” muffler. Do
not use this guard in tandem with both a deflector
and spark arrester.
SEMIAUTOMATIC MIG WELDING
WITH A LINCOLN WELD-PAK 100
OR WELD-PAK 125
In addition to using the accessories/options listed
above, the POWER-ARC 4000 generator can supply
power to a Lincoln ELectric Weld-Pak 100 or Weld-
Pak 125 wire feed welder. The Weld-Pak comes with
all the supplies needed for Flux-Cored Arc Welding
(FCAW).
A K610-1 MIG (Metal Inert Gas) Conversion Kit is also
available for the Weld-Pak. The kit provides every-
thing needed for Gas Metal Arc Welding (GMAW) or
MIG processes. Contact your local authorized
Lincoln representative for details about the Weld-Pak
and MIG Conversion Kit.
POWER-ARC 4000