Land Pride SPS20 Spreader User Manual


 
2
Important Safety Information
SPS20 & SPS30 Series Pulverizer Seeders 313-242M
6/26/02
Land Pride
Transporting the Loader
and Attachment
Always drive up the ramp with
heavy end uphill. Engage parking
brake.
Secure loader and attachments
using tiedowns and chains. Use
towing vehicle and trailer of
adequate capacity.
Practice Safe Maintenance
Understand procedure before
doing work. Use proper tools and
equipment, refer to Operator’s
Manual for additional information.
Work in a clean dry area.
Allow implement to cool
completely.
Do not grease or oil implement
while it is in operation.
Disconnect battery ground cable
(-) before servicing or adjusting
electrical systems or before
welding on implement.
Inspect all parts. Make sure parts
are in good condition & installed
properly.
Remove buildup of grease, oil or
debris.
Remove all tools and unused
parts from implement before
operation.
Getting On and Off Safely
Before leaving the
operator’s seat:
Lower lift arms and put
attachment flat on the ground.
Stop the engine.
Engage the parking brake.
Raise seat bar and move controls
until both lock.
Remove the key to prevent
unauthorized starting.
Use the steps, grab-handles and
skid-resistant surfaces when
getting on or off the loader.
While Operating
Start loader with steering levers
and hydraulic controls in neutral.
Keep bystanders away.
These are common practices that may or may not be applicable to the products described in
this manual.