Filter
Top Products
20
Section 4 Maintenance and Lubrication
SPS20 & SPS30 Series Pulverizer Seeders 313-242M
6/26/02
Land Pride
Section 4
Maintenance and Lubrication
50
Multi-purpose
spray lube
Multi-purpose
grease lube
Multi-purpose
oil lube
Intervals at which
lubrication is required
Lubrication
Legend
Maintenance
Proper servicingand adjustment can increase the lifeof any
implement. With careful and systematic inspection, you can
avoid costly maintenance, time and repair.
1. After using your seeder for several hours, check all
bolts to be sure they are tight.
2. After transporting your seeder for several hours,
check all wheel lugs, bolts and nuts to be sure they are
tight. Always maintain proper air pressure in the tires.
Storage
1. At the end of the working season or when your
Pulverizer Seeder will not be used for a long period, it
is good practice to clean off any dirt or grease that
may have accumulated on the seeder and any of the
moving parts.
2. Be sure that the seedbox is completely cleaned before
storing.
3. The square bore of the feed cup drive sprocket hub
should be oiled to prevent seizing. Squirt oil on to the
square feed cup shaft and move feed cup adjustment
lever back and forth in order to get the oil back into the
square.
4. Lubricate all fittings as indicated.
5. When in storage, lower the seeder with rollers on a
board or hard surface and adjust gauge wheels.
6. Repaint parts where paint is worn or scratched to
prevent rust.
7. Replace all damaged or missing decals.
8. Store the seeder inside if possible. Inside storage will
reduce maintenance and make for a longer seeder
life.
9. Inspect the pulverizer seeder for loose, damaged or
worn parts and adjust or replace if needed.
Lubrication
Feed Cup Drive Shaft
Type of Lubrication: Oil
Quantity = Generously
50
18531