Filter
Top Products
21
Section 5 Maintenance and Lubrication
7/14/08
RC45180 & RCM45180 Rotary Cutter 312-382M
Land Pride
Table of Contents
8
25
PTO Constant Velocity Shaft
Type of Lubrication: Multipurpose Grease
NOTE: To extend the life of the constant velocity joint,
extensive lubrication must be performed every 8 hours
of operation!
a. The constant velocity joint should be greased in
a straight position forcing grease through the
passages and into the cavity. After lubrication,
grease should be visible around the ball joints.
b. The constant velocity driveline comes equipped
with a grease zerk in the outer telescoping
member and must be greased every 8 hours to
prevent premature failure of the joint.
c. Grease fittings are located on the u-joints and
driveline shields and should be lubricated every
8 hours of operation.
12726
Drive line Shafts
Type of Lubrication: Multipurpose Grease
12725
Driveline Shaft
Type of Lubrication: Multi Purpose
Quantity = Coat Generously
10
14191