Filter
Top Products
Section 1: Assembly & Set-Up (Standard)
PSN2096 Primary Seeders 313-306M
4/03/08
Land Pride
8
Table of Contents
Section 1: Assembly & Set-Up (Standard)
Pre-Assembly Checklist
Sling Bracket
Refer to Figure 1-1:
The sling brackets allow points at each end to hook the
chain for lifting of the unit.
Sling Bracket
Figure 1-1
Check Reference
All major frame components.
Operator’s
Manual
Fasteners and pins that were
shipped with the seeder.
NOTE: All hardware from the factory
has been installed in the location
where it will be used. If a part or
fastener is temporarily removed for
assembly reasons, remember where
it goes. Keep the parts separated.
Operator’s
Manual
All working parts are moving freely,
bolts are tight and cotter pins are
spread.
Operator’s
Manual
If a pin, bolt or other part has been
removed, and you are unsure where
it is used, refer to the Parts Manual
to identify it. Be sure the part gets
used in the correct location. By
double checking while you
assemble, you will lessen the
chance of using a bolt incorrectly
that may be needed later.
Parts
Manual
All grease fittings are in place and
lubricated.
Section 4
Page 25
Safety decals are correctly located
and legible. Replace if damaged.
Important
Safety
Information
20577
Tire Track Remover Assembly
The Tire Track Removers are assembled 180 degrees
from their operating position for shipping purposes.
Refer to Figure 1-2:
1. Remove Track Remover (#1).
2. Flip Track Remover over 180 degrees and
reassemble as shown with 1/2” u-bolt (#4), lock
washer (#3) and nut (#2).
Tire Track Remover
Figure 1-2
20589