Filter
Top Products
9
Section 1 Assembly and Set-Up
10/28/05
Land Pride
Table of Contents
This procedure converts the valve to a closed center
operation. If the valve is set for closed center operation,
it may be converted back to open center by reversing the
above procedure.
Closed Center Hydraulic Systems
Figure 1-2
19617
A
B
Closed Center Hydraulic Systems
Power Beyond & Closed Center Kit
!
CAUTION!
If you are going to use a closed center tractor hydraulic system
to power your Land Pride Backhoe, A Power Beyond and
Closed Center Kit must be purchased from your Land Pride
Dealer, then you must carefully follow the directions below.
Failure to do so may cause extensive damage to your tractor
and/or Land Pride Backhoe.
Refer to Figure 1-2:
1. Adjust Valve Bypass for Closed Center
Conversion only (Kit #340-084A).
a. Remove the cover nut (#3) from the valve bypass.
This exposes a socket head screw.
b. Loosen locknut and turn socket head screw in
approximately four complete turns, then tighten
locknut.
c. Replace cover nut. Be sure to replace the washer
along with the cover nut as it acts as a gasket.
2. Installing the Closed Center Sleeve.
a. Return hose must be connected to the return
section of the valve at point “A” and with the other
end to the tractor.
b. Remove plug at point “B” and install the closed
center sleeve (#1). Use the plug (#2) that was
removed to plug the sleeve.
c. Connect return line to the adapter and return to oil
sump of the tractor.