Filter
Top Products
16 –English
INSTALLATION
Bolted jointAdjustable foot
Aligning the rails
Installation Site
The one-man sawmill with petrol engine should be
installed outdoors.
There should be space to lay out timber and sawn
wood.
Rails
Place the rail sections after each other on the
transverse wooden beams, which are placed under
each log bolster, and an extra transverse wooden
beam by the joints between the sections.
Installation
Unpack the one-man sawmill and check that the
delivery is complete. Check that no parts are
damaged. If any part is damaged, report this to the
carriers.
The operator’s manual includes detailed instructions
about safety, assembly, use, and maintenance of the
one-man sawmill.
Unpacking
1. Rail sections (quantity according to the order)
2. Saw carriage
3. Feed unit
4. 4 rail guards
5. Bar and chain
6. Assembly components
Parts that are included are pictured in the Description
section on page 7-9 . Component parts are packed
according to the following:
Continue as follows:
1.Assemble the adjustable feet under each of the 16
log bolsters. Adjust, by using the adjustable feet and
the rails’ bedding, until the rail sections form a
straight line and the rails sit firmly on each wooden
beam. See FIG. 21.
2.Loosely bolt together the rail sections using the
supplied jointing plates and M12 nuts and bolts. See
FIG. 23.
3.Finely adjust the rails and tighten all the bolts.
Tighten the bolted joints to 5-10 Nm. See FIG. 21.
4.Fit the stops to the ends of the rails (see page 14,
FIG. 11), as well as the folding stops, log lift, and log
lock (see page 13, FIG. 10).
5.Load the rails above each wooden beam and check
that the rails do not move.
FIG. 21
FIG. 22
FIG. 23